If you experience any problems, please visit
32
Wall mounting your phone
Before you wall-mount your BT Converse 1300,
check that you are not drilling into any hidden
wiring or pipes.
Make sure the telephone line cord will reach the
wall socket.
If you need to leave the phone whilst on a call,
hang the handset on the handset park at the top
left-hand side of the base.
1. Unclip stand from the base of the
phone and remove it. Re-route the
telephone line cord towards the
bottom of the phone.
2. Drill two holes in the wall 75-80mm
vertically apart using an 8mm drill bit.
3. Insert the wall plugs if necessary then
insert the screws leaving about 5mm
protruding from the wall on which to
hang the phone.
4. Slot the holes on the back of the base over the screw heads and gently pull the
phone down to make sure it is securely in place.
To Next Page
Loading...
