If you experience any problems, please visit
7Getting started
2. Fit the desk mounting plinth if required by positioning the plinth over the lugs
and pushing it down into place, as shown by the blue arrows.
3. Plug the other end of mains power adaptor into the wall socket and switch on.
4. Plug the end of the telephone line cord into the wall socket.
5. Check the dial mode setting.
The switch on the underside of your BT Converse 2300 is pre-set to
for tone dialling with timed break recall. If your phone does not work, try
setting the dialling mode to or .
If you are not sure which setting to use, please contact your service provider or
switchboard manager.
Your BT Converse 2300 is now ready for use.
If connecting to a switchboard you may need to
adjust the dialling mode setting to or using
the switch on the underside of the base.
If in doubt, please consult your service provider.
To Next Page
Loading...
