10- 14 Service Guide LWE180, LWE200, LPE200, LPE240 © BT Europe AB
Electrical systems – 5000 LPE 240
Error codes
T-code Valid from serial number Date Order number
660, 661, 662, 497 723984- 2005-05-11 225553-040
Code C4
Description TLS: Use of the truck has been blocked
Possible error
cause
Truck use can be “blocked” by a TLS command. /
The truck cannot be used until a new TLS com
-
mand cancels the blocking of the truck
Code C19
Description Parameter caution. Displayed for 5 seconds.
Possible error
cause
The parameters have probably been changed.
When changing/updating the program the param-
eters have automatically been changed to default
values (only applies to old program versions).
In later program versions the parameters are only
changed if they are outside the values permitted
by the new program.
Action 1. This means that the special parameters must
be reset manually.
Code C20
Description Speed control caution.
Possible error
cause
Problem with the speed control sensors.
The toggle switch may have been activated when
starting or there may be a fault on one of the sen
-
sors on the electronic card. (tiller arm head)
Action 1. Restart with the speed control in neutral
position.
2. Replace the electronic card.
To Next Page
Loading...
