BT LPE240 - Service Indication

Electrical System – 5000 LWE 180/200 LPE 200
Parameters
Order number Date Valid from serial number T-code
225553-040 2005-05-11 723984- 660, 661, 662, 497
© BT Europe AB Service Guide LWE180, LWE200, LPE200, LPE240 9- 47
_
Service indication
• Connect CAN key to X41 and start the truck
• Battery status is shown and symbol “D” is lit
• Press S18 to go to display mode.
See the table below.
*These are displayed by segments of three of the figures being marked (A).
Table 5: Standard PIN code assignment with the expanded
keypad
Driver profile
no.
0 1 2 3 4 5 6 7 8 9
Block 0 0000 0001 0002 0003 0000 0000 0000 0000 0000 0000
Block 1 5421 7901 1437 3731 1049 9439 7265 1322 2869 1574
Block 2 1787 4854 2907 9175 5799 1490 3031 7392 5622 5023
Block 3 4659 3174 1026 3815 6703 1179 5152 7514 5668 3215
Block 4 9197 7110 5477 3846 9491 5918 8222 6923 8139 7025
Block 5 2549 6276 9879 9658 1690 4042 5201 9807 4332 9715
Block 6 7474 4142 8620 3754 8432 8788 7430 1948 2595 8527
Block 7 1930 1482 7135 2395 7365 7092 4611 2831 4185 6067
Block 8 2876 4731 1022 5377 3257 7334 9009 7881 8843 7436
Block 9 3242 3162 5878 2828 1910 6907 2136 5730 2957 7691
Flashing symbol Data
B A speed reference value has been sent
to Curtis
C Digital inputs to Curtis and hall sensors.
* See explanation below
BC Battery voltage (V)
D Armature voltage (A)
BD Field current (A)
CD PWM (pulse width modulation) armature
in percentage
BCD Status of Curtis
A
B
C
DE