BT LPE240 - Parameters

Electrical systems – 5000 LPE 240
Parameters
Order number Date Valid from serial number T-code
225553-040 2005-05-11 723984- 660, 661, 662, 497
© BT Europe AB Service Guide LWE180, LWE200, LPE200, LPE240 10- 25
10.6 Parameters
• Press S18 and turn S17 to on at the same time.
• Press S18 until you read P= parameters.
• You have now choosen P=parameters the symbol “C” on display will
be highlighted to indicate what’s currently shown on display.
• Scroll to the parameter you want to change or look at by pressing the
L1 up or down.
• Press S18 ones to get access to the parameter.
• Set parameter value by pressing L1 up or down.
• Press S18 ones to confirm change.
• Turn S17 to off.
You have now completed a parameter change and the next time you
start the truck the new parameter setting will be valid.
NOTE !
Truck handling.
Modifying specific truck parameters will change the driving charac-
teristics of the truck.
Do not change any parameters without the necesarry know-how.
10.6.1 Driver parameters
Parameter Name Unit Min Max Step Std Description
1 Speed, low
Speed
% 10 100 5 100 10:low Speed
100:highest Speed
02 Speed, high
speed
% 10 100 5 100 10:low Speed
100:highest Speed.
03 Acceleration 10 100 5 75 10:low acceleration
100:full acceleration
04 Neutral speed
reduction
5 100 5 80 Defines motor speed
reduction force when
lever goes to neutral
position.
5: low reduction force
100: full reduction force
05 Logout 1min 0 20 1 20 The time it takes for the
truck to switch off when
the keypad is used. The
time counts down from
the moment the last
power-consuming unit
is used.
Value = 0 gives 4 hours.
In steps of 1
A
B
C
DE