Electrical System – 5000 LWE 180/200 LPE 200
Error codes
Order number Date Valid from serial number T-code
225553-040 2005-05-11 723984- 660, 661, 662, 497
© BT Europe AB Service Guide LWE180, LWE200, LPE200, LPE240 9- 17
9.5 Error codes
• Press and hold S18 while turning S17 to “ON” position.
• Press and hold S18 until E = error codes is displayed.
• When E is selected, the “E” symbol will light up as an indication of
what is shown in the display.
• The 50 most recent error codes are stored. The latest error is dis-
played first. The display shows the error code first, followed by the
time when the error occurred.
• The error codes are divided into two groups, C = caution and E = error.
• C codes are not stored. They are only cautions and remain lit in the
display as long as the fault remains.
• If there is only one error registered in the memory, the other empty
entry lines appear as follows: Error: E - - - and time: - - - - .
Code C3
Description TLS: Shock sensors registered values outside
the limits
Possible error
cause
A shock sensor has reported values that exceed
the truck’s tolerance values.
Driving may be too hard
Check that the shock sensor’s limit values are
correctly set.
Check that the shock sensor is correctly posi-
tioned./The brake engages and stops the truck.
The TLS reset command activates the truck
Code C4
Description TLS: Use of the truck has been blocked
Possible error
cause
Truck use can be “blocked” by a TLS command. /
The truck cannot be used until a new TLS com
-
mand cancels the blocking of the truck
To Next Page
Loading...
