EasyManua.ls Logo

BT LWE180 - Option Parameters; General; Parameter #15 Non-Configurable Options; Changing Non-Configurable Options

BT LWE180
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9- 34 Service Guide LWE180, LWE200, LPE200, LPE240 © BT Europe AB
Electrical System – 5000 LWE 180/200 LPE 200
Parameters
T-code Valid from serial number Date Order number
660, 661, 662, 497 723984- 2005-05-11 225553-040
Parameter 18 - Configurable option #3
See “Option parameters” on page 34, Servicemanual
Parameter 19 - Configurable option #4
See “Option parameters” on page 34, Servicemanual
Option parameters
WARNING !
Do not try to change these parameter unless you have specific knowl-
edge of the truck options or truck modifications. This service manual
only covers the truck’s standard equipment. Specially modified
trucks may require you to have access to particular service informa
-
tion. Incorrect adjustment of option parameters may result in incor-
rect function.
General
Parameters #15 to #19 have been reserved in the truck control system
for extra options and/or specific product modifications. These parame
-
ters are normally configured by the manufacturer on modification or
customisation of the truck. It is recommended that the parameter set
-
tings be loaded up from the truck when carrying out any modification. If,
for example, the main electronic card [A2] must be replaced, the origi
-
nal parameter settings can then be simply transferred to the new card,
which ensures that all the special options function correctly.
Parameter #15 Non-configurable options
Up to 16 so-called sub-parameters are stored under parameter #15.
Their status is either ON or OFF and they do not require any other
adjustments. They are therefore called non-configurable options.
Changing non-configurable options
Ensure the truck is in parameter mode.
The parameter symbol is lit.
Select parameter #15 using [L1].
The first set-up of sub-parameters is displayed
The next set-up of sub-parameters is displayed if you continue to acti-
vate the speed control L1. Ensure that only the relevant sub-parame-
ters are displayed.
The value of the sub-parameters is displayed after 1 second.
Press the horn button S18.

Table of Contents

Related product manuals