BTECH S5 BATTERY VALIDATION SYSTEM SCM-600 - Power On and Connect SCM-600

Operating Manual 19
Starting Up
2. Make sure the SCM-600 is turned on and connected
Action How to do it Picture
1
Turn on the SCM-
600.
• Flip the POWER toggle switch on back the SCM-600.
• Flip the ON toggle switch on the from of the SCM-600. The ON light should come on.
2
Connect the SCM
locally to your
computer.
Make sure one of the following wires is plugged into the SCM and also plugged into the computer
you are using:
• Serial (9-pin)
•USB