Operating Manual 21
Starting Up
4. Make sure the hardware is communicating with the software
Action How to do it Picture
1 Open a location file.
In the Location List window, click on a location file, then click OK.
2
Establish local
communications.
From the BVM
software menu bar,
select
Communications>
Establish Local
Communication
with Controller.
3
Select the
communications
port.
From the Local Communication Settings
window, select the port that the communications
cable is selected to, then click OK.
4
See if there are any
alarm notifications.
From the Communications - S5 Test,
click Retrieve Alarms.
The Equip Alarm light will light up if
there are problems.
5
Note which modules
are having problems.
Look at the
*.bvm file
window and see
which modules
are having
problems, if any.
Note that in this
example,
modules 1 and
12 are having
problems.
To Next Page
Loading...
