22 S5 Battery Validation System
6
Check system
configuration
From the Communications - S5 Test window,
click on Advanced, then click on System
Configuration.
7
Diagnose existing
errors.
a. From the System Configuration
window, click on Module Config.
(“Module” refers to a VM-24.)
b. Compare the number of assigned voltages in
each module with the number of actual voltage
readings.
i. In the Module Configuration window, look at
the Voltages column. This is how many voltage
readings the program should be finding.
ii. Click on the Module Diagnostics button.
Action How to do it Picture
To Next Page
Loading...
