BTECH S5 BATTERY VALIDATION SYSTEM SCM-600 - Install USB Drivers

12 S5 Battery Validation System
3. Installing Drivers for the USB Port on SCM-600
.
Steps to Install USB Drivers Screen Shot
For WINDOWS XP Installation from CD
1
The drivers should be installed from the BVM Installation CD. If the CD is not
available and the PC is connected to the Internet, the drivers can be installed via
Windows Update.
Connect the USB port on the SCM-600 to a free USB port on the PC or hub
connected to a USB port on the PC. This will bring up the Found New Hardware
Wizard. Select “No, not this time” on the wizard and click the Next button.
2
If the BVM Installation CD is not inserted, insert it now. Select “Install from a list
or specific location” and click the Next button.
3
Select “Search for the best driver in these locations” and make sure the “Search
removable media (floppy, CD-ROM) is checked. Then click the Next button.
4
The wizard will search for and install the first driver for the USB port. Click the
Next button when it is complete.
5 When the wizard finishing installing the driver, click the Finish button.