Operating Manual 13
Installing the Software
6
The Found New Hardware Wizard will again begin to install the next driver.
Select the “No, not at this time” on the wizard and click the Next button.
7 Select “Install from a list or specific location” and click the Next button.
8
Select “Search for the best driver in these locations” and make sure the “Search
removable media (floppy, CD-ROM) is checked. Then click the Next button.
9
The wizard will search for and install the second driver for teh USB port. Click
the Next button when it is complete.
10
When the wizard finishes installing the driver, click the Finish button. The BVM
will now be able to communicate with the SCM-600 via the USB port.
Steps to Install USB Drivers Screen Shot
To Next Page
Loading...
