42 S5 Battery Validation System
5
Enter location file
data.
a. In the Software Location Settings field, enter
the following data. This data will be seen by the
BTECH help desk if you ask for assistance.
• Location ID: This must match the number of
the SCM controller. It can be any number you
wish.
• Model: Select S5 for the SCM-600 alone, or
S5+PIT-12 if you are also using a Portable
Impedance Tester.
• Serial Number: Enter the serial number
posted on the back or side of the SCM control
module.
• Name: Name of the battery system you are
monitoring.
• Address: Your mailing address line 1
(optional)
• Address: Your mailing address line 2
(optional)
• Description: System description line 1
(optional)
• Description: System description line 2
(optional)
• Type of System: Type of battery system (e.g.
UPS or telecommunication)
• Type of Batteries: Type of battery used (e.g.
VLRA, Flooded, NiCad)
• Contact Info: Name of contact person at your
site
• Note 1: Additional info line 1 (optional)
• Note 2: Additional info line 2 (optional)
b. Click OK when done.
Action How to do it Picture
To Next Page
Loading...
