BTECH S5 - Brackets and Fasteners

Installation Manual 13
Getting Ready
Brackets and Fasteners
Qty Part Name Picture Purpose
varies
Stainless steel clamp (SS clamp)
To attach VSL pigtail quick
disconnect tabs to battery bars/
straps
1 per
thermistor
Thermistor installation kit (mounting
clips and insulated tape)
To attach thermistors to
batteries, walls or racks
varies
VM-24/CM-2 right angle mounting
brackets (pair)
To attach VM-24 and CM-2
modules to surface
varies
VM-24/CM-2 stacking brackets (pair)
To stack VM-24 and CM-2
modules on top of each other if
desired; used in pairs
varies
VM-24/CM-2 universal hanging
bracket
To attach VM-24 and CM-2
modules to any location that
accepts tie-wraps or screws
varies
Battery Terminal Hardware (hex nut,
flat washer, and split or star washer)
To attach VSL pigtail quick
disconnect terminals to battery
terminals
1 set per
SCM-600
SCM-600 Mounting Hardware Kit
For use with mounting rails or
brackets
1 per
SCM-600
SCM-600 Bottom Mounting Rails
(pair)
To mount an SCM-600 on a flat
surface
1 per
SCM-600
SCM-600 Rack Mounting Brackets
(pair)
To mount an SCM-600 inside a
rack
qty LCL
pigtails
In-line taps (various sizes)
To clamp an LCL pigtail onto a
battery cable