14 S5 Battery Validation System
Step 2: Gather Tools
Unless otherwise noted, these items are not provided by BTECH, Inc.
1 pair per
SCM-600
Bushing, plastic (1” and 7/8”)
Insert into SCM-600 chassis
knock-outs to protect wires /
cables that pass-through knock-
outs.
Qty Part Name Picture Purpose
Part Name Picture Purpose
Rubber insulating blanket
Lay on top of battery(s) to protect installer
from electrical shock
A #2 Phillips-head screwdriver with
insulated handle
For mounting the modules onto racks,
removing/attaching the back panel on the
SCM-600 case and/or attaching stainless
steel clamps
Tie wraps To bundle wires or cables together
Flat-headed short-handled screwdriver
For attaching a ground wire to the SCM-
600 and removing knock-out tabs from the
SCM-600 case
Hammer
For removing knock-out tabs from the
SCM-600 case
Wire cutter For cutting wires
Wire stripper
For preparing wires for insertion into
terminals
High-voltage insulated wrench (1/2”)
for small inline tap; 5/8” for mid-or
large inline tap; can use socket, open-
end, or box-end wrench
For tightening the bolt on an in-line tap
which attaches a load current lead (LCL)
to a battery cable
To Next Page
Loading...