Installation Manual 23
Installation Procedure
3. Protect yourself from
shock
4a, Install 1/4” male quick disconnect tabs on battery post, OR
4b. Install 1/4” male quick disconnect tabs on threaded insert, OR
4c. Install 1/4” male quick disconnect tabs on a battery strap
2. Rubber mat over
battery cells
12. 3D assembly drawing of the
steel clamp components, with the
disconnect tab included.
If possible, show that the set
screw must be tightened to 7 in-
lbs.
(Drawing 11)
11. Drawing of no-
ox grease being
applied to steel
bar.
To Next Page
Loading...