14
Android
The Android app can be found in the Google Play store- search for
“BTECH UV Programmer”. Once installed, verify Bluetooth is enabled on
your phone. Open the app, and you should see the main screen (Figure
10). Clicking the 3 lines (Hamburger) in the lower left will open the
connect window available radios will be shown in the “Bindable Device”
option list (Figure 11). Select your device and it should pair the phone
and radio. Once a radio is connected you will see the operating screen
(Figure 12). Your screen will look different and show the factory default
channel listings. Clicking the “gear” will open the main settings
window (Figure 13).
The options will be covered in a later chapter. Next is Connection
Management (Figure 14). Use this to scan for Bluetooth devices to
connect to. The next option is “Channels and Groups” (Figure 15).
Here changes are made to the memory channels and channel banks.
Next is Band Scan (Figure 16) this allows you to scan through a range of
frequencies to nd activity. In the next window (Figure 17) you can set
the different functions of the Programmable Buttons. The options are
shown in Figures 17 and 18.
Figure 10 Figure 11 Figure 12
To Next Page
Loading...
