VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP 5
Using the Radio
Turning the Radio On/Off
When the radio is off, turn the [Power/Volume] switch clockwise.
After the radio makes a “click”, the power of the radio is turned on.
The screen displays the model of the radio. After a few seconds, the
radio emits a beep, and the display becomes active.
When the radio is on, turn the [Power/Volume] switch counterclockwise
until the radio makes a “click” and the information displayed on the
screen disappears.
Volume Adjustment
When the radio is on, turn the [Power/Volume] adjustment (turn clockwise
to increase the volume; counterclockwise to decrease the volume) and
set the desired volume level. The screen will indicate the current volume
level through the progress bar.
Display Screens
In standby mode, press the left and right arrows to switch through the
standby displays.
This is the Main display when both Main
and Sub channels are active. The radio
name is shown on the lower left. In this
example the “CTC” to the right shows
the main band is in CTCSS receive mode.
The DCS shows the Receive mode (DCS)
of the Sub band. The “02” indicates
which memory channel is in use.
RX ( shows this symbol and number of bars relating to signal strength)
TX Power Level (L, M, H)
RX Ready - Switches to
^
(2) on TX and v (2) on RX
To Next Page
Loading...
