8
keyboard, such as 146.520, press OK to conrm, press the menu “save
to channel”, use the middle 4-way button select a blank channel to save
to, using the up/down arrows.
Saving Frequencies with CTCSS/DCS
In VFO mode, input the frequency you want through the number
keyboard, such as 446.000, press OK to conrm, Open the radio setting
menu, enter the transmit TX/RX subtone menu, select the required
subtone frequency, press OK to exit, press the menu “save to channel”,
select a blank channel to save.
Tips: In the CTCSS selection interface, use the keyboard to
input the corresponding CTCSS number within 1 second, and
you can quickly adjust to the corresponding CTCSS value.
For example: 754N. You only need to enter 75, 754N will
be displayed. Select it to set it successfully.
Editing Channels
Open the channel list menu, click Edit, edit the channel content, and
save it.
Frequency Scanning
Open the frequency scan menu, input the start frequency that you want,
then press the * key to switch the input frequency step, # key to switch
the scan step, press the left and right arrows to start scanning, left to
scan in up frequency, and right to scan down.
Tone Scanning
Set the frequency to be scanned on the standby page, open the Tone
scan menu, use the up arrow to set a frequency and it will start scanning
when a signal is received.
To Next Page
Loading...
