26
Receive Channels
Receive Team Mates channels. (UV-PRO users only)
Frequency Scan
Manually Scan Frequencies using front panel keys.
Tone Scanning
On the Selected Frequency, scan for RX tone Frequency when a signal is
received. The scan will not become active until there is a signal present.
It will stop on the correct frequency. This will scan CTCSS frequencies
and the DCS frequencies.
GPS Status
This will show your location as received from the GPS Satellites. If no
location is seen, make sure you are outside with a clear view of the sky.
Compass
This is used to calibrate then shows the compass.
Status
Battery level (Percentage left in batteries)
Battery Voltage
Installed Firmware Version
Unit Part Number
Pairing
Checking this will place the unit in Bluetooth Pairing Mode (Red/Green
light on top will start ashing until paired).
FM Radio
This will place the radio in FM Broadcast reception mode- use the
center up/down buttons for search direction- unit will stop when signal is
received.
To Next Page
Loading...
