12
3 Configuration
LEVEL 3 PASSEPARTOUT SETUP
Enable the passepartout function: YES = 1; NO = 0 (default).
Associate a passepartout code to the internal contact (default -0), or to an external
actuator with P address the same as that of the entrance panel (1).
Set up a new passepartout code.
Delete a passepartout code.
Delete all passepartout codes.
LEVEL 4 SWITCHBOARD
Call to the switchboard:
enabled = 1; disabled= 0 (default).
Change the SCS address associated to the switchboard (from 0 to 15).
The procedures described in the following sections must be performed after access-
ing the system using the master code and after entering the level of the function to be
programmed.
To Next Page
Loading...
Need help?
General
