14. Troubleshooting
Can't get a signal to the PC Base from a camera using a Yagi (Directional) antenna.
Make sure the antenna is pointed in the direction of the PC Base (see Chapter 10).
The antenna cable should be 400 series cable from Buckeye Cam.
Raise antenna higher if possible.
Upgrade the PC Base antenna to a 40” Omnidirectional mounted as high as possible using 400
series cable available from Buckeye Cam.
Can't get a signal to the Cell Base from a camera using standard antennas.
If the Cell Base is installed outdoors, try moving it closer to the camera, or to a more central
location if multiple cameras are registered to it.
There must be a limited amount of obstructions between the camera and the Cell Base. There
should be few trees, no large hills, buildings or structures.
Try mounting the antenna higher. If longer cable is required, use 400 series cable from Buckeye
Cam.
Upgrade the antenna at the camera to a Yagi (Directional) antenna. The Yagi antenna at the
camera should be pointed in the direction of the Cell Base.
X80 Wireless Camera User's Manual v2.0 33 of 35
To Next Page
Loading...