9. Camera Installation
9. Camera Installation
Attach camera to a solid structure.
The supplied spring buckle strap may be
used to attach the camera to a tree,
vertical post, or other solid structure.
Alternatively, it may be attached with a
screw or nail using the hole in the top
of the mounting bracket.
The best height for the camera will
depend on the primary target of interest.
Usually, the camera should be placed at
about the height of the center of mass
of the primary target of interest.
For maximum motion trigger distance,
the face of the camera should be
perpendicular to the ground.
If maximum motion trigger distance
is not critical, the camera may be placed
at an angle.
Connect battery pack.
If you have not done so already, install
the battery (see Chapter 7).
The supplied spring buckle strap may be
used to attach the battery pack to the
same solid structure as the camera.
It may also be attached with a screw or
nail using the hole in the top of the bracket.
Alternatively, the battery pack may be
placed on the ground. This may make it
easier to conceal.
The battery pack is watertight, however it
should not be submerged.
Once the battery pack is in place, connect
it to the camera with the supplied cable.
X80 Wireless Camera User's Manual v2.0 19 of 35
Install
1
Install
2
To Next Page
Loading...