3. Getting Started
3. Getting Started
If you are using a PC Base, Cell Base, or Net Base, follow the steps below to set up your system.
If you are using a Camera Base, go to chapter 13.
Install X-Series Network Manager and USB Modem Driver for Windows.
Use the supplied installation CD or download at
www.buckeyecam.com/site/support.html
Connect to a Base.
For PC Base refer to chapter 4.
For Cell Base refer to chapter 5.
For Net Base refer to chapter 6.
Register cameras.
Refer to chapter 7.
Adjust camera settings.
Refer to chapter 8.
Install cameras in their permanent location.
Refer to chapter 9.
X80 Wireless Camera User's Manual v2.0 5 of 35
Getting Started
1
Getting Started
2
Getting Started
3
Getting Started
4
Getting Started
5
To Next Page
Loading...