Page 28
REMOTE CONTROL OR
WALL THERMOSTAT
NOTE: Knob cannot be turned from “PILOT” to “OFF” unless knob is pushed in slightly.
Do not force.
6. Wait (5) five minutes to clear out any gas. Then smell for gas, including near floor. If you
smell gas, STOP! Follow “B” in safety information on reverse side of this label. If you
don’t smell gas, go to next step.
7. Find Pilot: The pilot is located in front of rear log and burner on right hand side of
appliance. Fully open the manual shutoff valve.
8. Press in and turn knob on gas control counterclockwise to “PILOT” and continue
pressing in the knob for (15) fifteen seconds.
9. With control knob pressed in push down (in) and release the igniter button (igniter button is
located on left hand side of front of appliance). This will light pilot. If needed, keep
repeating this step until pilot lights.
10. Keep control knob pressed in for (1) one minute after lighting pilot. After (1) minute,
release the control knob and it will pop back out. Pilot should remain lit. If pilot goes out,
repeat steps 1 through 9.
• If the knob does not pop out when released, stop and immediately call your service
technician or gas supplier.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information on the preceding page 27.
2. Make sure manual shutoff valve is fully closed. If equipped with thermostat, set to
lowest setting.
3. Turn off all electrical power to appliance.
4. Open access panel door.
5. Push in gas control knobslightly and turn clockwise to full “OFF” position.
To Next Page
Loading...