Logamatic SC40 - Technical specifications are subject to change without prior notice.
5
Details of the product
2
2 Details of the product
2.1 EU Declaration of Conformity
2.2 Package contents
2.3 Product description
The controller is designed for use with a solar thermal system. It can be mounted on a wall or is inte-
grated in a solar pumping station.
The design and operation of this product conform to the applicable European
directives and supplementary national requirements. Confirmity has been dem-
onstrated. You can request a copy from your local Buderus office.
– controller SC40
– Collector temperature sensor NTC 20K (FSK)
– Storage cylinder temperature sensor NTC 10K
– Fixings and cable clamps (for wall-mounting)
Additional components that may be required such
as temperature sensors, heat meters and valves
are available as optional accessories.
Fig. 1 Controller and temperature
sensors
In normal operating mode, the display screen on
the controller stays illuminated in green/yellow for
5 minutes after the last button was pressed (acti-
vated by pressing the rotary selector , for
example). The display shows the following:
– Pump status (as simple schematic diagram not
representative of actual system)
– System values (e.g. temperatures)
– Selected functions
– Fault messages
Fig. 2 Example of screen display
7747006071.06-1.SD
To Next Page
Loading...
