RECALL:
Press the upper knob briefly to recall the
station being played or to display the clock. To change
what
is
normally shown on the display (station or time),
press the knob until you see the display you want, then
hold the knob
until
the display flashes. If you press the
knob
when
the ignition is off, the clock
will
show for a
few seconds.
Finding a Station
AM-FM:
Press the AM-FM button to switch between
AM, FMl and FM2. The display shows your selection.
TUNE:
Turn the lower knob
to
choose radio stations.
SEEK:
Press the right or
left
arrow to go to
the
next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press one of the
SEEK
arrows for two seconds,
and SCAN
will
appear on the display. Use SCAN to
listen
to
stations for a few seconds. The radio will go to
a station, stop for a few seconds, then go on to the next
station. Press one of the
SEEK
arrows again to stop
scanning. The sound will mute while scanning.
PUSHBUTTONS:
The
six
numbered pushbuttons
let
you return to your favorite stations. You can set up to
18
stations (six AM, six FMl and six FM2). Just:
1
.
Turn the radio on.
2. Press the AM-FM button to select the band.
3.
Tune
in
the desired station.
4.
Press and hold one
of
the six numbered buttons. The
sound will mute. When
it
returns, release the button.
Whenever you press that numbered button, the
station you set will return.
5.
Repeat the steps for each pushbutton.
P
SCAN:
Press this button to listen to each of your
preset stations for a few seconds. The radio will
go
to
the first preset station, stop for a few seconds, then go
on to the next preset station. Press P
SCAN
again to stop
scanning. The radio
will
not stop at a preset station
if
the
station
is
weak.
3-13
To Next Page
Loading...
