Ignition Transaxle Lock Check
While parked, and with the parking brake set, try to turn
the ignition key to
LOCK
in
each
shift
lever position.
The key should turn to
LOCK
only when the shift
lever is
in
PARK (P).
The key should come out only in LOCK.
Parking Brake and Automatic Transaxle PARK
(P)
Mechanism Check
8
8
When you are doing this check, your vehicle
could begin to move.
You
or others could be
injured and property could be damaged. Make
sure there is room in front of your vehicle in case
it begins to roll. Be ready to apply the regular
brake at once should the vehicle begin to move.
Park on
a
fairly steep hill, with the vehicle facing
downhill. Keeping your foot on the regular brake, set the
parking brake.
To check
the
parking brake's holding ability: With
the engine running and transaxle in NEUTRAL
(N),
slowly remove foot pressure from the regular brake
pedal.
Do
this until the vehicle
is
held by the parking
brake only.
To
check the PARK (P) mechanism's holding ability:
With the engine running, shift to PARK (P). Then
release all brakes.
Underbody Flushing Service
At least every spring, use plain water to flush any
corrosive materials from the underbody. Take care to
clean thoroughly
any
areas where mud and other debris
can collect.
7-42