Front Turn Signal
The front turn signal bulbs can be accessed from under
the front of
the
vehicle. Reach up from under the vehicle
and, while pushing in the tab
on
the bulb assembly, turn
assembly counterclockwise and remove. Remove the old
bulb by pulling it straight out of the retainer. Replace the
bulb and
turn
the bulb assembly back into place.
Trunk Mounted Back-up and Taillamps
Cornering Lamps
Follow the same procedure as used for replacing
the
headlamps. However,
to
remove the cornering lamp
bulb, turn the bulb assembly counterclockwise and pull
the bulb straight
out.
1.
Loosen and remove the eight fasteners (four per
side) that hold the assembly in place. The assembly
for
both sides is one piece.
The
entire piece must be
removed to replace any bulbs.
6-32
To Next Page
Loading...
