If your vehicle has a
wheel cover, remove
it
by using the flat end
of
the wheel wrench.
Pry
along the edge
of
the wheel cover until it comes
off.
Be careful, the
rim
edges may be sharp. Don’t try to
remove it with your bare hands.
Note: When replacing
any
wheel cover, carefully line up
the tire valve stem and the notch in the wheel cover.
If
your vehicle has this
aluminum wheel,
you
may
have plastic wheel nut caps.
Use the wheel nut wrench
to remove the wheel nut
caps
and
to loosen the
wheel nuts.
When re-installing the decorative nut caps, tighten the
caps snugly with the wheel wrench, then continue
one-quarter rotation to secure plastic caps.
If
your vehicle has wire
wheel covers, remove
them as follows:
5-26
To Next Page
Loading...
