Then, without shutting
off
the engine, follow these steps:
1.
The transaxle
fluid
dipstick top is a
round loop and is
next to the brake
master cylinder
behind the engine
block. Pull out the
dipstick and wipe it
with a clean rag or
paper towel.
3.
Check both sides
of
the dipstick, and read the lower
level.
The
fluid level must be
in
the cross-hatched
area.
2.
Push
it
back in all the way, wait three seconds and
then pull it back out again.
4.
If
the fluid level is in the acceptable range, push
the
dipstick back in all the way.
6-18
To Next Page
Loading...
