To Next PageTo Next PageHow to fix BuildClean 512000 Scrubber that does not start?
If the BuildClean Scrubber doesn't start, ensure it's fully plugged into the outlet. Check that the power switch (red switch at the back) is set to “RESET”. Also, check the GFCI on the back of the unit and depress the “RESET” button. Finally, verify that there is no power failure in the outlet.
What to do if BuildClean Scrubber fan stops suddenly?
If your BuildClean Scrubber fan stops suddenly, first check if there was a power failure and restore power if necessary. If power is not the issue, the unit might be in an “ERROR” state; consult the Error State Table for guidance.
General| Brand | BuildClean |
|---|---|
| Model | 512000 |
| Category | Scrubber |
| Language | English |
Essential warnings and guidelines for safe operation and handling of the air scrubber.
Instructions for connecting the power cord and turning the unit ON.
Steps to initiate the air cleaning process and select fan speed.
Explanation of available fan speeds (Low, Medium, High, Auto) and their recommended uses.
Lists error codes and their corresponding solutions or causes.
