Burkert 8791 - ATEX Approval

10
Instructions on operation in the potentially explosive atmosphere
BVS 16 ATEX E 118 X
To install the electrical system using screw-type terminals and to
start up Type 8791 using DIP switches, remove the sheet metal
coverandthehousingcover:
→ Unscrew screws (4 x) on the housing cover.
→ Remove sheet metal cover together with the screws and
spacer sleeves.
→ Removehousingcoverandfoldtotheside.
→ Install or start up device.
Afterinstallingorstartingupthedevice,mountsheetmetalcover
andhousingcover:
→ Closehousingcover,ensuringthatthesealiscorrectlytted.
→ Attach sheet metal cover with screws and spacer sleeves
(see "Fig. 4").
→ Tightenscrews(4x)hand-tightasfarasthestop.
5.8 ATEX approval
TheATEXapprovalisonlyvalidifthemodulesandcomponents
authorized by Bürkert are used as described in these operating
instructions.
Use the devices only in combination with the valve types approved
by Bürkert, otherwise the ATEX approval will expire.
Ifanyunauthorizedchangesaremadetothesystem,modulesor
components, the ATEX approval will also expire.
This product is subject to review by the Shanghai Inspection
andTestingInstituteofInstrumentsandAutomationSystems
Co.,Ltd.(SITIIAS),hasbeenCCCcertiedtocomplywith
requirementsofnationalexplosion-proofseriesstandard(GB/T
3836.2021-Explosive Atmospheres).
TheEUType-ExaminationCerticate
BVS 16 ATEX E 118 X and
IECEx BVS 16.0091 X
was issued by DEKRA EXAM GmbH
Dinnendahlstraße 9
D-44809 Bochum
Germany
Production is audited by the PTB (CE0102).
english