Burmester 159 - Switching the Device On and Off

36 46
OPERATION MANUAL
THE DEVICE HAS TWO CONTROLS FOR SWITCHING IT ON AND OFF:
— The mains switch (10) is located on the rear of the device. Toggling the mains
switch connects or disconnects the standby power supply to/from the mains.
— The on/off switch (18) is located on the control panel on top
of the device. Toggling the on/off switch switches the device
between standby mode and operational mode.
WARNING: HIGHINTENSITY SOUND
Loud output signals can damage your hearing.
$
Before switching on the power amplifier, reduce the volume on your
preamplifier to a low level and only increase the volume after switching on
the power amplifier.
$
To prevent hearing loss, avoid listening at high volumes for long periods
oftime.
TO SWITCH THE DEVICE FROM OFF TO STANDBY:
$
Move the mains switch (10) on the rear of the device to the I position.
$
The device switches to standby mode. The LED (1) lights up red.
TO SWITCH THE DEVICE ON FROM STANDBY MODE:
$
Pull the on/off switch (18) on the control panel towards you or press the POWER
button (21) on the remote control.
$
The LED (1) flashes green while the device is starting up.
$
Once start-up is complete, the LED (1)remains steadily green.
$
The power amplifier is now ready for operation.
TO SWITCH THE DEVICE FROM OPERATIONAL TO STANDBY MODE:
Pull the on/off switch (18) on the control panel towards you or
press the POWER button (21) on the remote control.
$
The LED (1) flashes red while the power amplifier is switching to standby mode.
$
Once this process is complete, the LED (1)remains steadily red.
Switching the Device On and O