Burmester 159 - Configuring Auto Power Down

37 46
159 MONO POWER AMPLIFIER
$
The power amplifier is now in standby mode.
The mains switch (10) can remain in the I position. This allows you to conveniently
switch on the device using the on/off switch (18) or the remote control.
Very little power is consumed in standby mode because
only the standby power supply is active.
TO DISCONNECT THE DEVICE FROM THE MAINS:
1. Switch off the device using the on/off switch (18).
2. Switch the mains switch (10) to O.
NOTE:
Always switch the device off using the on/off switch
before switching the mains switch to O.
The device has an auto power down function. When this function
is activated, the device automatically goes into standby mode
if there is no signal for a configured amount of time.
If your power amplifiers are connected via BurSync, all connected power amplifiers
follow the settings of the BurSync master, which is the first 159 in the network.
CONFIGURING AUTO POWER DOWN
Press the auto power down button (20).
$
This switches the auto power down function to the next value:
Off  Short  Mid  Long  Off ...
Configuring Auto Power Down
Off Auto power down is deactivated.
Short The device switches to standby mode
after 30 minutes of inactivity.
Mid The device switches to standby mode
after 60 minutes of inactivity.
Long The device switches to standby mode
after 120 minutes of inactivity.