To Next PageTo Next Page
Need help?Do you have a question about the Burnham RSA and is the answer not in the manual?
General| Model | RSA |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Dimensions | Varies by model |
| Operating Pressure | 30 psi |
| Vent Size | Varies by model |
| Weight | Varies by model |
| Efficiency/AFUE | Up to 84% |
| Ignition Type | Electronic |
Standards and practices for installing boilers in the United States.
Standards and practices for installing boilers in Canada.
Inspect shipment for damage, file claims, and position the boiler considering installation requirements.
Maintain specified clearances to combustible walls and ensure proper ventilation air is provided.
Safely remove the boiler from its skid and test the heat exchanger for leaks before proceeding.
Install the boiler jacket, tankless heater coil/blank plate, and mount boiler controls as per diagrams.
Design piping to prevent oxygen entry and ensure long product life by eliminating leaks and open tanks.
Connect system piping, install safety relief valve, drain valve, and perform water treatment.
Install vent system according to instructions, local codes, and ensure sufficient chimney draft.
Evaluate chimney condition, heat loss, and efficiency to prevent condensation and deterioration.
Install wiring and ground the boiler according to jurisdiction and electrical codes.
Connect controls and wire the system according to diagrams for various system configurations.
Use flexible lines, recommended filters, and flared fittings for oil supply installation.
Install fuel units for single-pipe or two-pipe systems, ensuring airtight lines and proper lift.
Verify installation, check supplies, fill the system with water, and purge air from all zones.
Set room thermostat, reset primary control, and adjust aquastat controller settings for optimal operation.
Conduct annual inspection and clean firetubes using a brush, avoiding damage to the combustion chamber.
Order replacement parts through distributors or manufacturers, providing model and serial numbers.
Understand LWCO requirements, select an appropriate location, and install using a tee fitting.
Wire the LWCO according to boiler voltage and test its function by simulating low water conditions.
One-year warranty on residential boilers and parts against defects; includes heat exchanger and nipple warranties.
Outlines warranty applicability, limitations, exclusions, and the procedure for obtaining warranty service.
