Why is the display panel blank but fan running on my Burnham FREEDOM Boiler?
If the display panel on your Burnham Boiler is blank but the fan is running, it could be due to a loose 120VAC connection in the wiring between the boiler J-Box and the MCBA or a blown 'F1' fuse in the MCBA. Replace the fuse with the provided 5A fuse.
How to fix Burnham FREEDOM Boiler displaying U.125?
If your Burnham Boiler display continuously reads 'U.125' and the fan is running, it could be caused by a defective AT250 transformer or a blown 'F3' fuse in the MCBA. Replace the fuse with the provided 4A slow-blow fuse.
Why does my Burnham Boiler fire but the display is blank?
If the Burnham Boiler fires, but the display panel is blank, it could be due to a loose ribbon cable or a defective display.
Details on securing the boiler to a framed wall using mounting holes.
Explains horizontal, vertical, and twin-pipe vent system configurations for the boiler.
Details on installing primary/secondary piping for consistent boiler flow.
General| Model | FREEDOM |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Efficiency | Up to 95% AFUE |
| Water Content | Varies by model |
| Dimensions | Varies by model |
| Weight | Varies by model |
| AFUE | Up to 95% |
| Boiler Type | Condensing |
| Ignition | Electronic Ignition |
| Heat Exchanger Material | Stainless Steel |
| Vent Type | Direct Vent |
| Warranty | Limited 5-year warranty on parts |
To Next Page
