Bush CDVD90W2SW - User Manual

Protective Card Disc
QUICK SETUP GUIDE
1. Remove the battery cover (as shown).
2. Insert 2 x AAA batteries, taking note that the polarities
match up.
3. Replace the battery cover.
Before using the built-in battery, please make
sure it is fully charged.
Slide the power switch to the OFF position and connect the
DC adaptor to the DC input & mains supply. When the
battery is fully charged the red LED charging indicator will
go off.
NOTE: The battery can only be charged when the power
switch is set to OFF.
1 2 3
1
3
2
Please refer to page 5 of the supplied manual
for remote control & button layout functions.
1. Use the navigation buttons on either the main unit or the
remote control to navigate the DVD menu.
2. Press the OK or ENTER button to select the menu item
and begin playback of the DVD disc.
4
CHARGE
1. Remove the Protective disc from the tray.
2. Slide the power switch to ON.
3. Insert a DVD and close the tray lid
4. Wait a few seconds for the disc to be read.
5. The DVD will begin to play automatically.
If you have damaged or missing parts,
call the Customer Helpline: 0870 600 3030
CDVD90W2SW

Bush CDVD90W2SW Specifications