Bush CDVD90W2SW - Installation; Electrical Connection

7
Electrical connection
Installation
Any electrical work that is required to
install this appliance MUST be carried out
E\DTXDOL¿HGHOHFWULFLDQ
Before making any electrical connections,
ensure the following:
 Do not bend, stretch or pull the supply cable in
order to avoid electric shock.
 The supply voltage should be the same as that
LQGLFDWHGLQWKHWHFKQLFDOVSHFL¿FDWLRQVDQGWKH
appliance rating plate.
 When installed, the power socket must be
within easy reach.
 If the socket outlets in your home are not
suitable for the plug supplied with this
XQLWFKHFNZLWKDTXDOL¿HGHOHFWULFLDQIRU
replacement.
 The use of multiple connectors or extension
cables are not recommended.
 The appliance must be connected to a 220-240
volt 50Hz AC supply by means of a three pin
socket.
 The main plug is used as the disconnect
device, the disconnect device shall remain
readily operable.
 In order to disconnect the apparatus from the
mains completely, the mains plug should be
disconnected from the mains socket outlet
completely.