Bush CDVD90W2SW - Safety Precaution

3
Important – Please read these instructions fully before installation
Safety Precautions Locations
Safety Information
7KHOLJKWQLQJÀDVKZLWKDUURZKHDGV\PEROZLWKLQ
DQHTXLODWHUDOWULDQJOHLVLQWHQGHGWRDOHUWWKH
user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that may
EHRIVXI¿FLHQWPDJQLWXGHWRFRQVWLWXWHDULVNRIHOHFWULF
shock to persons.
7KHH[FODPDWLRQSRLQWZLWKLQDQHTXLODWHUDO
triangle is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
The symbol for CLASS II (Double Insulation).
:$51,1*7RUHGXFHWKHULVNRI¿UHRUHOHFWULFVKRFNGR
not expose this appliance to rain or moisture, dangerous
high voltages are present inside the enclosure. Do not
RSHQWKHFDELQHWUHIHUVHUYLFLQJWRTXDOL¿HGSHUVRQQHO
only.
CAUTION: When replacing the direct plug in power
supply or a separable, cord-connected power supply,
the replacement must be exact duplicate, or one
recommended by the manufacturer.
This is a CLASS-1 laser product. Use of controls or
DGMXVWPHQWVRUSURFHGXUHVRWKHUWKDQWKRVHVSHFL¿HG
herein, may result in hazardous laser light beam exposure.
Do not open the cover and do not repair yourself. Refer
VHUYLFLQJWRTXDOL¿HGSHUVRQQHO
DANGER: Visible and invisible laser radiation
when open and interlock failed or defeated.
Avoid direct exposure to laser beam.
 Do not locate the unit in places near heating devices,
high temperature (40C or higher), high humidity
RUKLJKHUGLUW\SODFHVDQGDYRLGGLUHFW
exposure to sunshine.
 The pick up may be condensed with water under the
following situation.
)URPDFROGSODFHWRZDUPSODFH
2SHUDWHVLQDURRPZKHUHWKHKHDWHULVMXVW
turned on, or a place where the cold air from the air
conditioner directly hits the unit.
'XULQJVXPPHUWKHXQLWPRYHVIURPDQDLU
conditioned room to a hot and humid place.
$URRPLVYDSRURXVRUGDPS
 If condensation exists, the unit will not operate
properly. Remove the disc, power up the unit and
leave it for two to three hours. The unit will warm up
and evaporate any moisture.