5
Check the package contents
The package contains:
• 1 x Retro DAB/FM Radio
• 1 x mains adaptor
• 1 x instruction manual
Where to put your Radio
It is important that you consider carefully in advance where your Radio will be situated
and make sure that it is:
• on a flat and stable surface
Note: Never place your Radio directly onto antique or polished surfaces.
• within 1.4 metres of a power socket (if using mains power). Please ensure that the
mains power lead is not a trip hazard.
• at least 1 metre away from other electrical appliances to avoid interference
• where you can fully extend the telescopic aerial
• away from bright sunlight or heat sources, such as a radiator
• not in a humid or very damp place such as a bathroom
Setting up
1. Connect the mains power lead into the socket on the back of the Radio and fully
extend the radio aerial in a vertical position to obtain the maximum signal strength.
2. Plug the power adaptor into the mains power wall socket and switch on.
3. Rotate the On/O wheel on the top of the radio to ‘On’. The display will light up
and ‘Welcome to Digital Radio’ will be displayed.
4. Press and release the ‘Standby’ button on the top of your radio. Your radio will
switch on and begin an automatic scan for DAB radio stations. A progress bar will
show the progress of the scan and the number of stations found during the scan
will also be displayed.
When the scan is complete your radio will select the first available station and
begin to play. Stations are listed in numerical and then alphabetical order by
default.
Note: The DAB radio station list is stored in the memory and so the next time you
switch your radio on, the station search does not take place. It is possible to scan
manually for stations. Please see page 9.
Instructions for use
To Next Page
Loading...
