To Next PageTo Next PageWhy is my Bush F841QB not draining water?
If your Bush Washer is not draining water, consider the following: * Check the drain hose for any obstructions or bends. * Clean the pump filter, as it may be obstructed. * Ensure that the clothes are spread inside the machine in an orderly and well-balanced manner.
Why is my Bush Washer not receiving water?
If your Bush Washer isn't receiving water, check these potential causes: * Ensure the water tap is open. * Inspect the water inlet hose for any bends. * Clean the filters of the water inlet hose if they are obstructed. * Clean the valve inlet filters if they are obstructed. * Confirm that the door is completely shut; you should hear a click.
What to do if my Bush F841QB does not operate?
If your Bush Washer isn't working, there are several things to check: * Ensure the washer is properly plugged into the socket. * Check the fuse and replace it if defective. * Verify that there is electric power. * Make sure you have pressed the start/pause button. * Confirm that the programme knob is not in the '0' (off) position. * Ensure that the door is completely shut; you should hear a click.
Why is my Bush Washer vibrating so much?
If your Bush Washer is vibrating excessively, it could be due to: * The feet of the machine not being properly adjusted; adjust them as needed. * The transportation screws not being removed; remove them before using the machine.
Why is there excessive foam in the detergent drawer of my Bush F841QB Washer?
Excessive foam in the detergent drawer of your Bush Washer can be due to: * Using too much detergent. To stop the foam, press the start/pause button, dilute one tablespoon of softener in half a liter of water, and pour it into the detergent drawer. After 5-10 minutes, press the start/pause button again. In the next wash, use the correct amount of detergent. * Using the wrong type of detergent. Ensure you are using detergents specifically produced for full automatic machines.
What to do if the washing result is not good in my Bush Washer?
If the washing result from your Bush Washer isn't satisfactory, consider these points: * Avoid loading clothes exceeding the maximum capacity of the machine; ensure you load appropriately. * Your water may be hard; use the amount of detergent specified by the detergent manufacturer. * Ensure the distribution of the clothes inside your machine is well-balanced; spread them in an orderly manner.
Why is the washing result poor with my Bush F841QB?
If you're experiencing poor washing results with your Bush Washer, it might be because: * Your laundry is too dirty for the programme you have selected; try selecting a more suitable programme. * The amount of detergent used is not sufficient; try using more detergent.
Why is water drained from my Bush F841QB as soon as it is filled?
If water drains from your Bush Washer immediately after filling, it's likely because the end of the water drain hose is positioned too low. Adjust the water drain to an appropriate height.
Why are there residues of detergent on the clothes after washing with my Bush F841QB Washer?
If you notice detergent residues on clothes after washing with your Bush Washer, it may be because some detergents contain ingredients that don't dissolve well in water, causing white stains. To resolve this, adjust your machine to carry out an additional rinse, or eliminate the stains after drying with a brush.
Why is the spinning process not working or delayed in my Bush F841QB?
The spinning process in your Bush Washer might be delayed because the unbalanced load control system is working as intended. This system distributes your clothes evenly. Once distributed, the spinning process will begin. For the next wash, ensure clothes are placed in a well-balanced manner.
General| Maximum Spin Speed | 1400 rpm |
|---|---|
| Energy Efficiency Class | A+++ |
| Washing Capacity | 8 kg |
| Capacity | 8 kg |
| Spin Speed | 1400 rpm |
| Energy Rating | A+++ |
| Number of Programs | 15 |
| Weight | 68 kg |
Manual providing instructions for installation and user guidance for the washing machine.
Crucial advice to read before installing or using the appliance for safe and correct operation.
Guidelines for safe installation and preparation, including handling, positioning, and connections.
Critical warnings for safe operation, including child safety, electrical safety, and appliance handling.
Identification of visible parts on the front of the washing machine, including detergent drawer and door.
Identification of parts on the back, including power lead, drain hose, and water inlet.
List of accessories provided with the washing machine, such as hoses and plugs.
Instructions for safely unpacking the appliance and checking for any visible damage.
Procedure for removing transit bolts to prevent damage and allow the machine to function correctly.
Guidance on levelling the machine by adjusting its feet for optimal performance and reduced vibration.
Instructions for correctly connecting the water inlet hose to the machine and water supply valve.
Guidance on positioning and connecting the drain hose to ensure proper water drainage.
Essential electrical safety precautions and connection requirements, including earthing and plug specifications.
Step-by-step instructions for replacing the power plug, including wiring colour codes.
Identification and function of the detergent drawer and its compartments.
Description of the programme selection dial used to choose washing cycles.
Overview of the electronic display panel and its indicators.
Instructions for using the liquid detergent apparatus for optimal detergent dispensing.
Detailed explanation of the main wash, softener, and pre-wash detergent compartments.
Details on the main compartment for detergent, lime preventer, and other additives.
Information on using compartments for fabric conditioner, starch, and pre-wash detergent.
Guide to selecting washing programs by turning the programme knob to the desired setting.
Explanation of the electronic display's functions, indicators, and status messages.
Detailed breakdown of the display panel's indicators for washing stages, time, and spin speed.
Identification and purpose of the various buttons for auxiliary functions and program control.
Instructions on how to set a delayed start time for the washing operation.
Procedure for cancelling a pre-set delayed start time.
How to adjust the spin speed of the selected washing program.
Guide to activating Easy Ironing for reduced creasing and Extra Rinse for improved washing.
How to start, pause, or suspend the washing program using the Start/Pause button.
Instructions for enabling and disabling the child lock to prevent accidental program changes.
Steps to follow to cancel a washing program that is currently in progress.
Information on how the program finishes and post-wash actions like drying.
Steps to follow before operating the machine for the very first time, including initial test run.
Guidance on sorting, loading clothes, and preparing laundry for washing.
Information on selecting and using the correct amount of detergent for different load types.
Steps to take before cleaning the appliance, including unplugging and closing the water tap.
Instructions for cleaning the water inlet filters to ensure adequate water supply.
Procedure for cleaning the pump filter to maintain drainage efficiency and prevent lint buildup.
Instructions for cleaning the detergent drawer, liquid apparatus, and siphon plug.
Guidance on cleaning the exterior cabinet surface with appropriate cleaning agents.
Advice on avoiding metallic objects in the drum to prevent rust stains.
Instructions for cleaning rust stains using non-chlorine agents.
Detailed specifications including model, power, pressure, load capacity, and dimensions.
Guidance on proper disposal and recycling of the appliance according to environmental regulations.
Details of the guarantee period, coverage, exclusions, and conditions for validity.
Information on how to contact customer support for issues covered under the guarantee.
