BYD SEAL - Page 136

information bar by pressing and
, and then select the tire pressure
display page using the roller on the
button.
Tire Pressure System Alarm
●
When the pressure of any tire is
lower than 80% of the standard tire
pressure and the system is running, the
tire pressure fault warning light lights
up and the tire pressure value turns
yellow. In that case, it is recommended
to check for slow air leakage and
in󽗊ate the tire to the correct pressure
value.
●
When the temperature of any tire
is above 85°C for 3 consecutive
minutes, the tire pressure system
will give a high temperature alarm,
and the temperature value of the
corresponding tire will turn yellow.
You are then recommended to stop
the vehicle and wait for the tire
temperature to decrease before further
driving.
●
When one or more tires leak air quickly
and the system is running, the tire
pressure fault warning light 󽗊ashes
constantly and the tire pressure value
turns red. In that case, promptly stop
the vehicle and replace tires or contact
a BYD authorized dealer or service
provider.
●
When the system is running, if a
fault occurs, the tire pressure fault
warning light is solid on after 󽗊ashing,
and the message "Abnormal signal"
or "Please check the tire pressure
monitoring system" is displayed on
the instrument cluster. In that case,
check the tire pressure monitoring
module, and for any surrounding
electromagnetic source nearby. If the
alarm persists for a long time, please
contact a BYD authorized dealer or
service provider.
CAUTION
●
The running time of the tire
pressure monitoring module is
related to the daily travel distance
and other factors.
●
The monitoring module regularly
transmits tire pressure and
other information to the display.
Therefore, if the tire pressure
drops suddenly or there is a 󽗊at
tire, the monitoring module will
not transmit data to the display
until the next monitoring. In this
case, the vehicle may be out
of control. If there is a 󽗊at tire
and monitoring fails to inform,
or if you feel that there are
some tire problems, stop driving
immediately instead of waiting for
the display to signal an alarm.
●
Incorrectly installed monitoring
module a󽗈ects the air tightness of
the tire. It is recommended that
the installation and replacement
of the pressure monitoring
module be carried out by
professional technicians of a
BYD authorized dealer or service
provider in accordance with the
requirements of the installation
manual.
●
Since tire pressure varies with
regional temperatures, in󽗊ate
or de󽗊ate the tires according
to the values displayed on
the instrument cluster and the
standard tire pressure values.
●
The tire pressure monitoring
system may be disturbed by
non-BYD approved electrical
accessories on the vehicle. This is
not a tire pressure system failure.
●
The tire pressure system needs
to be matched again after
replacement of wheel rims or
135
04
USING AND DRIVING