BYD SEAL - Wiper Switch

Wiper Switch
Front Windshield Wipers and Washer
●
The lever is used to control the
windshield wipers and washer. It has
󽗉ve modes:
●
: High-speed
●
: Low-speed
●
: Auto Wipers/Intermittent
●
: Stop
●
: Point-wiping
●
To select a mode, push up or pull down
the lever.
●
At low- and high-speed modes, the
wiper operates continuously.
●
To let wipers work in the spot-wiping
mode
, pull the lever from the
position. The wipers wipe at a low
speed until you release the lever.
Auto Wipers/Intermittent
●
The rain sensor automatically controls
the operation mode of wipers based on
the rainfall, and it is located in front
of the interior rearview mirror on the
front windshield inside the vehicle.
●
To use the automatic wiper function,
turn the wiper switch to the automatic
mode, go to the Infotainment
touchscreen → Vehicle Settings →
Greeting and toggle Automatic Wiper
on.
●
To use the intermittent wiper function,
turn the wiper switch to the automatic
mode, and toggle Automatic Wiper o󽗈
in Infotainment system
→ Vehicle
Settings → Greeting.
●
The automatic wiper function has four
sensitivity levels. The higher the lever,
the higher the sensitivity. When using
the automatic wiper function, change
the sensitivity by adjusting the toggle
based on real-time rain conditions. If
the wiper reacts to rain too quickly,
reduce the sensitivity; if the wiper
reacts to rain too slowly, increase the
sensitivity.
Front Windshield Wipers and Washer
●
The front windshield washer spray and
wiper are activated when the stick
is pulled back towards the steering
wheel.
●
The washer spray will stop when the
stick is released, and the wipers will
operate twice then stop.
74