BYD SEAL - Page 177

●
If leather gets wet, wipe it with a clean
soft cloth and let it dry in a cool,
ventilated place.
●
For any questions about vehicle
cleaning, please consult a local BYD
authorized dealer or service provider.
CAUTION
●
If dirt cannot be cleaned o󽗈 using
a neutral detergent, clean it with
a detergent that does not contain
organic solvents.
●
Do not clean leather with any
organic material such as volatile
oil, alcohol, gasoline, acid or
alkali, as these will cause
discoloration.
●
Do not clean leather with a nylon
brush or synthetic 󽗉ber cloth,
as these may scratch the 󽗉ne
patterns on the leather surface.
●
Mold may grow on dirty leather
trimmings. Special care must be
taken to avoid oil stains, and
atrimmings must always be kept
clean.
●
Prolonged exposure to sunlight
will cause leather to harden or
shrink, so the vehicle should be
parked in a shady and cool place,
especially in the summer.
●
In hot weather, avoid placing vinyl
or waxy items on the trimmings,
as these may stick to leather in
high temperatures.
●
Improper cleaning of leather
trimmings may cause
discoloration or spots.
Self-Maintenance
Self-Maintenance
Self-Maintenance Precautions
●
If maintenance is to be carried out by
the owner, be sure to follow the correct
steps speci󽗉ed in this section.
●
Note that improper and incomplete
maintenance will a󽗈ect the good use
of the vehicle.
●
This section only lists instructions on
simple maintenance items that can be
done by the owner. However, there
are many items that must be done
by quali󽗉ed technicians with special
tools.
●
Special care must be taken in
maintaining vehicles to prevent
accidental injuries. Make sure to obey
the followings:
CAUTION
●
Some vehicle circuits and parts
carry high current or high voltage.
Beware.
●
If refrigerant spills out, wipe it
clean with a dry cloth or paper
to prevent damage to parts or
painted surfaces.
●
If brake 󽗊uid spills out, rinse it
with water to prevent damage to
parts or painted surfaces.
●
When replacing wiper blades,
prevent them from scratching the
glass surface.
●
Before closing the hood, make
sure there are no tools, cloths,
etc., left inside.
176