BYD SEAL - Page 183

●
When cleaning the windshield, raise
the wiper arm in advance. The speci󽗉c
operation method is as follows:
1. Go to infotainment system and tap
Vehicle health → Maintenance to
enable front wiper maintenance.
The wiper is rotated down.
2. Grasp the upper end of the wiper
arm and carefully lift the wiper arm
and blade assembly.
Tires
●
For safe driving, tires must be made
and sized to 󽗉t the vehicle, with good
tread and standard tire pressure.
●
The following pages provide details on
how to check tire pressure, damage to
and wear of tires, and the operating
method for tire transposition.
WARNING
●
Using excessively worn tires, or
with too high or low pressure,
poses a high risk of accidents.
●
Follow all of the instructions in
this manual on tire in󽗊ation and
maintenance.
Tire
In󽗊ation
●
Keep tires properly in󽗊ated to
provide the best combination of
maneuverability, tread life and driving
comfort.
●
Under-in󽗊ated tires can cause uneven
tire wear, a󽗈ect steerability and energy
consumption, and are prone to leakage
due to overheating.
●
Over-in󽗊ated tires reduce riding
comfort and are prone to damage from
uneven roads. In severe cases, the risk
of tire bursting poses severe threats to
the safety of the entire vehicle. Over-
in󽗊ation will also cause uneven wear
and tear of tires, a󽗈ecting tire service
life.
●
When tires are cold, you can decide
whether to replenish tire pressure
according to the tire pressure values
displayed on the instrument cluster.
●
Tire pressure should be measured
while tires are at ambient
temperatures. This means that it
should be measured at least three
hours after stop. If you must drive
the vehicle before the tire pressure is
measured, tires can still be considered
at ambient temperatures as long as the
travelled distance is not more than 1.6
km.
●
It is normal that tire pressure reading
measured while tires are hot (after
travel of several kilometers) is 30-40
kPa (0.3-0.4 bar) higher than when tires
are cold. In that case, do not de󽗊ate
tires in order to achieve the speci󽗉ed
cold tire pressure reading; otherwise,
the tire pressure will be insu󽗋cient.
REMINDER
●
The recommended tire pressure
label (stuck on the driver's
side door frame) indicates the
recommended cold tire pressure.
●
Tubeless tires have a self-
sealing function when they are
punctured. However, as the leak
is usually very slow, as soon as
the tire begins to depressurize,
carefully look for the leak
location.
Checks
●
Whenever checking tire in󽗊ation,
check tires for damage, foreign body
piercing and wear.
182