BYD SEAL - Page 58

②Vehicle Lock Button*
●
Press the lock switch on the valid
smart key, the trunk will be closed
and the vehicle is locked. If the vehicle
power is o󽗈, the anti-theft mode will
be activated.
REMINDER
●
Before closing the trunk, verify
that the doors, windows, sunroof,
etc. are closed to avoid property
loss.
Emergency unlocking the trunk from
inside the vehicle
1. Pull up the folding release clasp on the
seat back to fold the rear seat back.
2. There is an emergency unlocking
mechanism on the lid cover, open the lid
cover in the car by pulling the emergency
opening lever on the left (as shown in the
󽗉gure).
REMINDER
●
When the entire vehicle is
powered o󽗈, the trunk can be
unlocked from inside the vehicle.
Setting the trunk lid opening height*
●
Stop the opening lid motion at the
desired position. Press and hold the lid
switch for at least 3 seconds to set lid
height. There will be a beep to indicate
that the height has been successfully
set.
●
When the ignition is switched o󽗈,
press and hold the microswitch while
carrying the smart key to roll up
or down all windows. (To enable
or disable this function, go to the
Infotainment touchscreen → Vehicle
settings → Window and Lock.)
Anti-pinch Function
If the lid receives a hindering force while
it is closing, it will automatically switch
to the opposite direction. If it receives a
hindering force while it is opening, it will
halt.
If the electric trunk lid function fails
If the electric trunk lid function fails,
manually close it completely and the
function will recover.
Low-Voltage Battery (12 V)
Do not move the lid when it is opening or
closing automatically.
57
03
CONTROLLER OPERATION