BYD SEAL - Switches Operation

●
Press the button to switch to
level-1 menu and its submenus on
the left.
●
Press the
button to switch to
level-1 menu and its submenus on
the right.
Call
●
Press this button to make or receive a
call. (The audio system is muted at the
same time.)
●
When a Bluetooth-unrelated screen is
currently displayed, press this button
to switch to the phone selection screen
if Bluetooth is disconnected, or to the
Dial screen if Bluetooth is connected.
●
After entering a phone number on the
Dial screen or selecting a record on the
Call Log or Contacts screen, press this
button to dial the number.
●
When Bluetooth is connected, but no
phone number is entered on the Dial
screen, press this button to switch to
the Call Log screen. Press this button
again to call the 󽗉rst dialed number on
the call history.
Speech recognition
●
Press this button for the infotainment
touchscreen to switch to the voice
recognition screen.
●
Press this button again to re-enter a
voice command.
Instrument cluster/Back
●
When the instrument cluster is not
in the menu mode, press Instrument
cluster/Back to show the instrument
cluster menu.
●
When the instrument cluster is in menu
mode, press this button to return to
the upper-level screen, or to exit the
menu if there is no upper-level screen.
●
When dialing on the Bluetooth
interface, press it to end the call.
Mode
●
Selecting a mode: Press the Mode
button to switch between media apps,
peripherals, and pre-installed third-
party audio/video apps.
Horn
●
Press the horn button area to honk the
horn, and release to stop honking.
CAUTION
●
Avoid pressing honking for too
long, as the horn may be
damaged.
REMINDER
●
Observe the tra󽗋c laws and use
the horn reasonably.
Manual Adjustment of Steering Wheel*
●
To adjust the angle or axial position
of the steering wheel, do the following
while holding the steering wheel:
●
Press the steering wheel adjustment
handle down to adjust the steering
wheel to the desired position and
return the handle to its original
position.
70