LySonix 3000
®
with PulseSelect™ Operation Manual
40-OM-0002 Page 34 of 43 Rev B
7.2 Mechanical Limit Alarm Reset
7.2.1 Release Footswitch.
7.2.2 Depress Footswitch again. If Mechanical Limit Light and Audible Alarm sounds, refer to
Troubleshooting Guide.
7.3 Electrical Fault Alarm Reset
7.3.1 Switch ULTRASOUND ENABLE switch OFF.
7.3.2 Flip MAIN POWER switch OFF. Refer to Troubleshooting Guide and go through ALL
steps given.
7.3.3 Flip MAIN POWER switch ON and then ULTRASOUND ENABLE switch ON.
7.3.4 Depress Footswitch. If Electrical Fault Alarm activates again, DISCONTINUE USE,
REPLACE ENTIRE SYSTEM WITH BACKUP, SET UP AND TEST BACKUP and
continue operation. Call Byron Medical Inc., for further instructions.
To Next Page
Loading...
