16 xGenConnect Installation and Programming Guide
Other regulations
INCERT
The following options and values are mandatory for INCERT T031ed2
regulations.
• Engineer tamper reset: On.
• The cabinet must be equipped with a cam lock (item 1 in figure below). In
case of retrofit from NX-4 to NXG-4, the cam lock must be ordered
separately, part number 600-CL.
Caution: NXG-8(E)-CB panels and NX-003-CB large metal housings are
delivered with optional housing stand-offs.
Using stand-offs is not compliant with EN 50131-1 and INCERT.
To Next Page
Loading...